Analysis of spring-in deformation in L-shaped profiles pultruded at different pulling speeds: Mathematical simulation and experimental results

Alexander Vedernikov, Alexander Safonov, Fausto Tucci, Pierpaolo Carlone, Iskander Akhatov

Результат исследований: Глава в книге, отчете, сборнике статейМатериалы для конференциирецензирование

3 Цитирования (Scopus)

Аннотация

Peculiarities of the pultrusion manufacturing process lead to the occurrence of spring-in deformations, whereas their value depends on the pulling speed. In this article experimental and numerical analysis was carried out for glass fiber/vinyl ester resin 75 × 75 × 6 mm L-shaped profiles pultruded at pulling speeds of 200 and 600 mm/min. Spring-in angles of produced profiles were determined on the same day of manufacturing when profiles cooled down to room temperature. Higher pulling speeds provoked increased values of spring-in. 2D numerical model accounting for thermo-chemical and mechanical composite's behavior during pultrusion was implemented in ABAQUS software. Cure Hardening Instantaneous Linear Elastic (Chile) constitutive law was used to describe matrix resin Young's modulus evolution. Since both unidirectional (UD) rovings and fabric material were utilized, effective mechanical properties of UD and fabric layers were calculated in accordance with Self-Consistent Field Micromechanics (SCFM) approach. Spring-in angles determined within experimental and numerical studies were compared and a good correlation was found: the errors were 12.6% and 6% for the pulling speed of 200 and 600 mm/min, respectively.

Язык оригиналаАнглийский
Название основной публикацииESAFORM 2021 - 24th International Conference on Material Forming
ИздательPoPuPS (University of LiFge Library)
ISBN (электронное издание)9782870193020
DOI
СостояниеОпубликовано - 2021
Событие24th International ESAFORM Conference on Material Forming, ESAFORM 2021 - Virtual, Online, Бельгия
Продолжительность: 14 апр. 202116 апр. 2021

Серия публикаций

НазваниеESAFORM 2021 - 24th International Conference on Material Forming

Конференция

Конференция24th International ESAFORM Conference on Material Forming, ESAFORM 2021
Страна/TерриторияБельгия
ГородVirtual, Online
Период14/04/2116/04/21

Fingerprint

Подробные сведения о темах исследования «Analysis of spring-in deformation in L-shaped profiles pultruded at different pulling speeds: Mathematical simulation and experimental results». Вместе они формируют уникальный семантический отпечаток (fingerprint).

Цитировать