Influence of the feed variation of tool wear when machining Inconel 600

M. Balazinski, J. Litwin, C. Fortin

Research output: Contribution to journalArticlepeer-review

6 Citations (Scopus)

Abstract

Experimental results of the turning of Inconel 600 show that it is possible to change the tool wear mechanism and to increase tool life substantially by a proper variation of the cutting feed rate throughout the cutting process. Experiments clearly demonstrate this phenomenon and show a decrease of approximately 33% of the tool wear. Comparison between constant and variable feed processes are based on constant volume of material removed in a given time span, therefore maintaining a constant process efficiency for both cases. The results presented in this paper are based on a limited number of experiments and are therefore preliminary in nature.

Original languageEnglish
Pages (from-to)659-669
Number of pages11
JournalTransactions of the Canadian Society for Mechanical Engineering
Volume17
Issue number4 A
DOIs
Publication statusPublished - 1993
Externally publishedYes

Fingerprint

Dive into the research topics of 'Influence of the feed variation of tool wear when machining Inconel 600'. Together they form a unique fingerprint.

Cite this